{
    "dataType": "CVE_RECORD",
    "dataVersion": "5.2",
    "cveMetadata": {
        "cveId": "CVE-2026-79978",
        "assignerOrgId": "e2e69745-5e70-4e92-8431-deb5529a81ad",
        "state": "PUBLISHED",
        "assignerShortName": "zephyr",
        "dateReserved": "2026-08-25T16:06:30.868Z",
        "datePublished": "2026-10-23T19:56:14.995Z",
        "dateUpdated": "2026-10-23T19:56:14.995Z"
    },
    "containers": {
        "cna": {
            "providerMetadata": {
                "orgId": "e2e69745-5e70-4e92-8431-deb5529a81ad",
                "shortName": "zephyr",
                "dateUpdated": "2026-10-23T19:56:14.995Z"
            },
            "title": "Out-of-bounds write in the ADXL345 sensor driver RTIO streaming FIFO read path",
            "descriptions": [
                {
                    "lang": "en",
                    "value": "The RTIO streaming completion callback adxl345_process_fifo_samples_cb() in drivers/sensor/adi/adxl345/adxl345_stream.c clamps the amount of FIFO data it will report (read_len = MIN(fifo_bytes, buf_avail)) to the space actually returned by rtio_sqe_rx_buf(), but then queues one 6-byte bus read per hardware FIFO entry at consecutive offsets from read_buf, bounded by the device-reported entry count rather than by the clamp. When the allocated buffer is smaller than a full batch, the driver writes up to 186 bytes past the end of the allocation; a companion defect left data->fifo_total_bytes un-reset at batch start, so an aborted or errored chain could leave a stale write offset that pushes the next batch's writes out of bounds as well.\n\nA short buffer is an expected, first-class outcome of the RTIO allocator: rtio_block_pool_alloc() walks the requested size down one block at a time until a contiguous run is available, and the driver only demands sizeof(struct adxl345_fifo_data) + 6 bytes as its minimum. Any streaming configuration whose mempool block granularity is smaller than a full FIFO batch (204 bytes) — for example the sensor shell's RTIO_DEFINE_WITH_MEMPOOL(sensor_read_rtio, 8, 8, 32, 64, 4) used by sensor stream <dev> on fifo_wm incl, or the 16-byte-block streaming example in the documentation — takes this path whenever the pool is fragmented or the consuming thread falls behind.\n\nThe out-of-bounds writes are performed by the I2C/SPI RTIO backend (DMA on many SoCs) into the shared RTIO block pool, corrupting neighbouring live buffers or, for a pool smaller than one batch, memory beyond the pool itself. The written bytes are accelerometer samples and the destination follows the allocation, so there is no controllable corruption primitive: the realistic impact is silent corruption of other RTIO consumers' data or a crash. Reaching it requires a board with an interrupt-wired ADXL345 built with CONFIG_ADXL345_STREAM, plus buffer-pool starvation, which a co-resident local workload can induce but which also occurs spontaneously under load; there is no network, USB or radio path to this code."
                }
            ],
            "affected": [
                {
                    "vendor": "zephyrproject",
                    "product": "zephyr",
                    "collectionURL": "https://github.com/zephyrproject-rtos/zephyr",
                    "packageName": "zephyr",
                    "defaultStatus": "unaffected",
                    "programFiles": [
                        "drivers/sensor/adi/adxl345/adxl345_stream.c"
                    ],
                    "programRoutines": [
                        {
                            "name": "adxl345_process_fifo_samples_cb"
                        }
                    ],
                    "versions": [
                        {
                            "version": "4.0.0",
                            "status": "affected",
                            "versionType": "semver",
                            "lessThanOrEqual": "4.4.2"
                        }
                    ]
                }
            ],
            "references": [
                {
                    "url": "https://github.com/zephyrproject-rtos/zephyr/commit/3451bb1e1e9165844060551164adb8a756e7b6b7",
                    "name": "Fix commit",
                    "tags": [
                        "patch"
                    ]
                },
                {
                    "url": "https://github.com/zephyrproject-rtos/zephyr/security/advisories/GHSA-4v56-r4qm-v964",
                    "name": "GHSA-4v56-r4qm-v964"
                }
            ],
            "metrics": [
                {
                    "format": "CVSS",
                    "cvssV3_1": {
                        "version": "3.1",
                        "vectorString": "CVSS:3.1/AV:L/AC:H/PR:L/UI:N/S:U/C:N/I:L/A:L",
                        "baseScore": 3.6,
                        "baseSeverity": "LOW"
                    }
                }
            ],
            "problemTypes": [
                {
                    "descriptions": [
                        {
                            "lang": "en",
                            "description": "bounds",
                            "cweId": "CWE-787",
                            "type": "CWE"
                        }
                    ]
                }
            ],
            "x_generator": {
                "engine": "cvelib 1.8.0"
            }
        }
    }
}