spi: spi-qpic-snand: write the feature value before executing SET_FEATURE
cve-program · CVE-2026-80712 · Published
No access to your tenant or devices. Every item links to its source. What this means
In the Linux kernel, the following vulnerability has been resolved: spi: spi-qpic-snand: write the feature value before executing SET_FEATURE qcom_spi_send_cmdaddr() programs NAND_FLASH_CMD/NAND_EXEC_CMD and submits the descriptors, which makes the controller execute the command immediately. For SPINAND_SET_FEATURE the value to be written is only placed into NAND_FLASH_FEATURES afterwards, by qcom_spi_io_op(), in a second submission - so the chip is programmed with whatever that register happened to hold from a previous operation, and the intended value is only applied by the *next* SET_FEATURE. Measured on a TP-Link Archer AX55 v1 (IPQ5018, ESMT F50L1G41LB): writing 0x40 to the configuration register (0xb0) leaves the chip at 0x00, and the subsequent write of 0x00 leaves it at 0x40 - every write lands one operation late. This stayed unnoticed until v6.18 added SPI-NAND OTP support together with OTP entries for ESMT chips. spinand_otp_rw() enables OTP mode, reads, and disables it again, and mtd_otp_nvmem_add() does this during MTD registration. With the off-by-one, the "disable" write actually applies the previously requested value, so CFG_OTP_ENABLE ends up set: the chip stays in OTP mode, every subsequent array read returns the OTP area instead of the array (UBI reports an empty device) and all writes fail with -EIO because the OTP area is write protected. On this board that makes the whole flash unusable and the device unbootable. Write the feature value into NAND_FLASH_FEATURES as part of the same transaction, before NAND_EXEC_CMD. While at it, copy only the bytes the operation actually carries - the previous code dereferenced a 4-byte pointer on a one-byte buffer (spinand->scratchbuf). With this patch the flash contents read back bit-identical to a known-good dump of the same board taken under the vendor firmware (md5-verified across partitions), and writes work.
Read the publisher's advisoryCISA KEV lists vulnerabilities known to be exploited. FIRST EPSS estimates the likelihood of exploitation in the next 30 days. An unavailable score does not mean zero risk.
This view includes predictions for CVE identifiers explicitly listed in public NuGet advisories. Microsoft release pages have their own prediction coverage. Check source status for the scope and latest checks.
No exploitation or prediction data is available here for these CVEs. This does not mean they are safe or unlikely to be exploited.
Compare earlier KEV listings and EPSS scores. Advisory wording and affected versions have a separate history.
A prediction change is reported when EPSS rises from below 10% to 10% or higher. Every daily score change from the last 30 days stays in this history. Before that, it keeps KEV changes and moves between EPSS bands (0.1%, 1%, 5%, 10%, 20%, 50% and 90%).
See how the publisher's advisory changed over time. Each link opens the version saved at that time. The publisher's update date can differ from the date shown here.
Each link identifies one complete publisher record. History can include advisories that previously shared an identifier; an identifier removed by a publisher no longer establishes a current relationship. A historical link shows only that record and earlier saved versions. Failed checks and unchanged reads do not create new versions.
cve-program · CVE-2026-80712 · Published